25 Years of Excellence 1982 - 2007 Supplying and Manufacturing Quality Truck Equipment & Accessories   Home Request Form Site Map Back to NRC page Slider main page     Slider specs See Diagram Below Standard Equipment 60 Ton hydraulic wrecker 128" sliding boom Locks on sliding system Dual 50,000lbs DP planetary winches 7/8" x 175' steel cable on each drum Air clutch release on winches Cable tensioners Direct mounted tridem hydraulic pump Dual 8" bore x 54 7/8" cylinder for power boom elevation Lock & safety valve on elevation cylinder Two stage power boom extension Directional boom sheave Nylon slide on boom Dual independent hydraulic rear stiff legs Removable spades for stiff legs Lubrication fittings on all moving parts Dual controls Lights in lever controls 3 Pressure gauges Heavy duty body 100" wide Two toolboxes (24 Cubic Ft.) 242" C.A. (from cab to center of rearmost axle) Hi-tensile steel used for structural parts Sandblast + Epoxy primer paint Undercoating underneath the body Monocoque body Door checks & hold backs Rear mounted recovery anchors Safety chains (2 - 3/8" x 15' grade 7) Air plug (truck must have trailer air system) Federal standard #108 light group Electric plug Mud flaps Optional Equipment Reinforcement plate under the cab Reinforcement plate under the cab & bunk "L" shape mounting plate 3/8 "L" shape mounting plate T1 steel 3/8 Third stage boom Super heavy duty axle-lift + 4 sets of forks + tie down chains Longer tunnel toolbox 48" or 52" or 56" or 60" Battery box inside the tunnel toolbox Work lights in toolboxes Light pylon Aluminum cover inside the light pylon Winch covers Aluminum checker plate on top of tunnel toolbox Aluminum checker plate on rear steps 2 Work lights under the bumper Stainless on boom Stainless on mast Stainless on light pylon Stainless on bottom of body Stainless on winch covers Stainless on lever controls Stainless on top of body's sides One-color paint (acrylic enamel) One-color paint (IMRON) Installation (includes PTO)